An experimental study of fault slips under unloading condition in coal mines
Zhang, Ningbo; Zhang, Zong‑Xian; Shan, Renliang; Qi, Qingxin; Zhao, Shankun; Sun, Zhongxue; Guo, Yanshuang (2023-03-17)
Zhang, N., Zhang, ZX., Shan, R. et al. An experimental study of fault slips under unloading condition in coal mines. Bull Eng Geol Environ 82, 126 (2023). https://doi.org/10.1007/s10064-023-03125-3
© The Author(s) 2023. This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
https://creativecommons.org/licenses/by/4.0/
https://urn.fi/URN:NBN:fi-fe20230926137455
Tiivistelmä
Abstract
To investigate the mechanism of fault slips in coal mines, a biaxial shear experiment was carried out under unloading condition based on the fault F16 in Yima city, China. Two rock samples were used in the experiment and each sample was composed of two triangular sandstone blocks which were put together to simulate the fault. One rock sample was used to do fault slip tests and it was called slip-test sample. The other sample for comparison with the slip-test one was untested, and it was named non-slip-test sample. During the biaxial shear experiment of the slip-test sample, normal and shear strains near the fault, acoustic emission (AE) signals, and the sliding displacement were measured. After the experiment, microscopic profiles of fault surfaces of both rock samples were examined by scanning electron microscope (SEM). In addition, a numerical simulation was conducted to model the slip of the fault F16. The results indicate that: (1) three fault slips occurred during the biaxial shear experiment, and the shear stress, normal and shear strains in the first slip showed the maximum variation among three slips; (2) Shear strains near the two ends of the fault had a more significate variation than that in the middle part, and the typical trend of shear strains was first dropping, then increasing rapidly, and then falling slowly to a specific value during the first slip; (3) The first slip had the largest sliding displacement of 29.89 μm, and in the first slip three phases including slow slip, main shock and aftershock occurred based on AE monitoring results. (4) On the fault surface of non-slip-test sample, microstructures such as bulges, voids and veins were ubiquitous and notable, making the fault surface much rough, while similar microstructures were few and the fault surface of the slip-test sample was flattened after fault slips; (5) The slipping direction in the shallow part and deep part of the fault F16 were opposite during mining.
Kokoelmat
- Avoin saatavuus [32049]