Tuotantokoneiden käyttötehokkuuden parantaminen
Niemi, Antti (2021)
Julkaisun pysyvä osoite on
https://urn.fi/URN:NBN:fi:amk-2021052410630
https://urn.fi/URN:NBN:fi:amk-2021052410630
Tiivistelmä
Opinnäytetyön tarkoituksena oli selvittää, miten parantaa tuotantokoneiden käyttötehokkuutta Leanin eri työkaluja käyttäen ja määrittäen OEE-luku yhdelle koneelle. Opinnäytetyön toimeksianto tuli Turun Sarjatuote Oy:ltä. Tarkoituksena oli tehdä tutkimus, jota hyödyntäen voidaan määrittää tietynlainen järjestys, puhtaus ja laatu. Tulevaisuudessa ne helpottavat työntekoa.
Työssä perehdyttiin Leanin ajatusmaailmaan ja erityisesti 5S-toimintatapaan, joka helpottaa yleisen järjestyksen pitämistä ja näin ollen tekee työn teosta sujuvampaa. Työn lopussa käytetään OEE-laskentaa selvittämään koneen nykyistä tehokkuutta.
Työssä selvisi, että parannettavaa on vielä ja tehokkuutta mittaamaan tarvitsisi kehittää uusia keinoja. Työstökoneiden keräämää dataa ei hyödynnetä sen täydellä potentiaalilla. The objective of this thesis was to resolve how to improve effiency of development work with different Lean tools and determine OEE figure for one machine. This thesis was commissioned by Turun Sarjatuote OY. The purpose of this thesis was to do research that can be used determine a certain order, cleanliness and quality that will relief future working.
At the work focuses in the principles of lean, especially the way of how 5S works, which helps relieve common order in workshop and therefore makes working fluent. At the end of the work is used OEE calculation, to determine the current effiency of the machine.
The work revealed, that there is room for improvement and new ways to measure the efficiency should be created. The data collected by the machine centers is not utilized by its full potential.
Työssä perehdyttiin Leanin ajatusmaailmaan ja erityisesti 5S-toimintatapaan, joka helpottaa yleisen järjestyksen pitämistä ja näin ollen tekee työn teosta sujuvampaa. Työn lopussa käytetään OEE-laskentaa selvittämään koneen nykyistä tehokkuutta.
Työssä selvisi, että parannettavaa on vielä ja tehokkuutta mittaamaan tarvitsisi kehittää uusia keinoja. Työstökoneiden keräämää dataa ei hyödynnetä sen täydellä potentiaalilla.
At the work focuses in the principles of lean, especially the way of how 5S works, which helps relieve common order in workshop and therefore makes working fluent. At the end of the work is used OEE calculation, to determine the current effiency of the machine.
The work revealed, that there is room for improvement and new ways to measure the efficiency should be created. The data collected by the machine centers is not utilized by its full potential.