Thermally Induced Rock Stress Increment And Rock Reinforcement Response

Loading...
Thumbnail Image
Journal Title
Journal ISSN
Volume Title
Conference article in proceedings
This publication is imported from Aalto University research portal.
View publication in the Research portal
View/Open full text file from the Research portal
Date
2016-05-10
Major/Subject
Mcode
Degree programme
Language
en
Pages
10
Series
7th International Symposium on In-Situ Rock Stress, RIL
Abstract
The thermal heating caused by the deposition of spent nuclear fuel containers increases the in situ rock stress during disposal time. The thermal stress increase was modelled using thermo-mechanical modelling. The numerical codes used to establish the effects of heating on the in situ stress field are outlined, together with the rock mass parameters, in situ stress values, radiogenic temperatures and reinforcement structures. This is followed by a study of the temperature and stress evolution during the repository's operational period and the effect of the heating on the reinforcement structures. It is found that, during excavation, the maximum principal stress is concentrated at the transition areas where the excavation profile changes and that, due to the heating from the deposition of spent nuclear fuel, the maximum principal stress rises significantly in the tunnel arch area of NW/SW oriented central tunnels. However, it is predicted that the rock’s crack damage (CD, short term strength) value of 99 MPa will not be exceeded anywhere within the model. An additional study of the radiogenic heating effect on the brittle deformation zones is included. The main conclusion is that, despite deep reaching damage potential in all the load cases studied the currently designed and used reinforcement types and configurations (rock bolts, shotcrete) are capable of handling the dead weight of the damaged rock should this occur, with damage occurring on the shotcrete liner. The long term safety and stability of the repository during its lifetime can be guaranteed by perceiving the reinforcement strategy in two stages. Firstly, by installing the rock reinforcement to sustain the initial stresses and short term increases from the start of deposition with a monitoring programme in place. Secondly, by installing additional reinforcement, if found necessary through monitoring and observation of the underground facilities. In this way, the effect of any time dependent rock stress increase affecting the reinforcement structures can be observed, in addition to creep based damage, thus providing a better level of safety than a single stage design.
Description
Keywords
Olkiluoto repository, radiogenic heating, rock reinforcement, rock damage modelling, design, monitoring
Other note
Citation
Ström , J , Hakala , M , Suikkanen , J , Siren , T , Uotinen , L & Nuijten , G 2016 , Thermally Induced Rock Stress Increment And Rock Reinforcement Response . in E Johansson & V Raasakka (eds) , 7th International Symposium on In-Situ Rock Stress : Symposium proceedings . RIL , Suomen rakennusinsinöörien liitto RIL , Tampere, Finland , International Symposium on In-Situ Rock Stress , Tampere , Finland , 10/05/2016 .