Studies on characterization of dielectric composite materials using radar and other microwave sensors

Loading...
Thumbnail Image
Journal Title
Journal ISSN
Volume Title
School of Electrical Engineering | Doctoral thesis (article-based) | Defence date: 2016-09-09
Date
2016
Major/Subject
Mcode
Degree programme
Language
en
Pages
165 + app. 69
Series
Aalto University publication series DOCTORAL DISSERTATIONS, 155/2016
Abstract
This thesis describes several new advances in measurement of the properties of materials using microwave techniques. The developments were made through an interdisciplinary approach to explore the properties of composite materials such as biofuel, concrete, asphalt and the rock inclusions of asphalt. In this thesis, a composite material has been defined as inhomogeneous material with inclusions that have dimensions comparable to the measurement wavelength. Resonators were chosen to characterize materials in which the properties, such as moisture, are linked directly to the real or imaginary part of the measured signal, using either a linear or parabolic statistical fitting. The concepts were tested using online moisture measurement of biofuel employing a stripline cavity resonator at approximately 360 MHz, attached above and below the conveyor belt. In a similar manner, a resonant coaxial surface sensor operating at approximately 1.7 GHz was used to test the same concepts by determining the moisture content of concrete. Investigations into the use of radar techniques for material characterization employed a radar device (13–17 GHz), which was developed by colleagues to achieve a resolution (2–3 cm) sufficient for gaining an image of the structure of only the surface layer (< 5 cm). It is suggested that the use of polyoxymethylene (POM) or similar dielectric is preferable for radar calibration, as the reflectivity is of the same order as the material under test unlike in traditionally used metal sheets, which can cause saturation of the receiver. The permittivity of the asphalt aggregates was measured using both the resonator and waveguide methods as a precursor to measuring composites. Then, a scanner (7–17 GHz), which measured the transmission scattering parameters of a sample, was used as a laboratory reference method. This produced a two-dimensional color image of the permittivity and hence structure of the composite material with a resolution of 5 mm x 5 mm. Phase error due to multiple reflections was compensated by fitting a line to the fluctuating phase through the minima and maxima of the amplitude. Another signal processing routine was developed to filter out the multiple reflections so that the frequency-dependent permittivity was derived based on only the single-pass propagation through a concrete slab over 0.8–12 GHz. Further, a new algorithm was developed to perform direct interpretation of the GPR data. A color map was superimposed on top of a conventional grey-scale GPR image to distinguish materials based on their reflection-related phase.

Tässä poikkitieteellisessä väitöskirjassa esitellään uusia tuloksia dielektristen materiaalien sähköisten ominaisuuksien mittaamisesta ja karakterisoinnista RF- ja mikroaaltotaajuuksilla. Tutkimuskohteena ovat erityisesti komposiittimateriaalit kuten biopolttoaine, betoni, asfaltti ja sen kiviaines. Tässä työssä komposiittimateriaalilla tarkoitetaan sellaista materiaalia, jonka raekoko on merkittävä verrattuna mittauksessa käytetyn signaalin aallonpituuteen. Resonaattoriperiaate on valittu menetelmäksi suorassa karakterisoinnissa, jossa materiaalin ominaisuudet kuten kosteus liitetään mitatun signaalin reaali- tai imaginääriosaan. Biopolttoaineen tehdasmittauksessa liuskajohtoresonaattori (360 MHz) kiinnitettiin liukuhihnan molemmin puolin. Kosteus johdettiin mittaustuloksista. Kosteusmittaus tehtiin myös betonille koaksiaalisella pinta-anturilla (1.7 GHz). Molemmille kokeiden mittaustuloksille tehtiin sekä parabolinen että suoralle sovitus. Näin suhteellinen resonanssitaajuuden siirtymä on suoraan verrannollinen näytteessä olevaan kosteuteen. Uusi asfalttitutka (13–17 GHz) on kehitetty ohuita asfalttikerroksia varten (< 5 cm). Saavutettu resoluutio (2–3 cm) mahdollistaa pelkän pintakerroksen rakenteen kuvantamisen. Tutkan kalibroimiseen ehdotetaan työssä POM-muovin tai vastaavan eristeen käyttöä, koska sen heijastusvaste on lähempänä tutkittavan materiaalin aiheuttamaa toisin kuin perinteisesti käytetyllä metallilla. Metalli voi myös aiheuttaa tutkan vastaanottimen saturoitumista ja epälineaarisuutta. Asfaltin kiviaineksen permittiivisyys on tutkittu erikseen resonaattori- ja aaltoputkimenetelmillä. Skanneria (7–17 GHz), joka mittaa näytteen läpäisyparametrit, käytetään vertailumenetelmänä laboratoriossa. Mittauksesta johdetut asfaltin permittiivisyysarvot esitetään kaksiulotteisena väripintana. Skannerilla saadaan kuva komposiittimateriaalin rakenteesta 5 mm x 5 mm askelvälillä. Läpäisymittauksen vaihevirheen kompensointiin ehdotetaan uutta menetelmää. Vaiheeseen sovitetaan suora, joka kulkee vastaavien taajuuksien amplitudin minimi- ja maksimikohtien kautta. Toisessa kokeessa betonin läpäisymittauksen moninkertaiset heijastukset näytteen sisällä suodatettiin aikaikkunoinnin avulla. Betonin permittiivisyys johdetaan signaalin yksinkertaisen läpäisyn perusteella näytteen paksuuden mitalta. Menetelmällä saadaan betonin taajuusriippuva permittiivyys kaistalla 0.8–12 GHz. Uusi algoritmi on kehitetty maatutkadatan (GPR) tulkintaan. Mustavalkoinen maatutkakuva asetetaan päällekkäin algoritmilla saadun värillisen maatutkakuvan kanssa, jolloin kohteet näkyvät eri väreillä perustuen niiden heijastuksen vaiheeseen.
Description
Supervising professor
Vainikainen, Pertti, Prof., Aalto University, Department of Radio Science and Engineering, Finland
Viikari, Ville, Assist. Prof., Aalto University, Department of Radio Science and Engineering, Finland
Eskelinen, Pekka, Prof., Aalto University, Department of Electrical Engineering and Automation, Finland
Thesis advisor
Laitinen, Tommi, Dr.
Mikhnev, Valeri, D.Sc. (Tech.), National Academy of Sciences of Belarus Minsk, Belarus
Keywords
composite material, non-destructive testing, radar signal processing, radar target classification, RF moisture measurement, ainetta vahingoittamaton testaus, kohteen tunnistus tutkalla, komposiittimateriaali, RF-kosteusmittaus, tutkasignaalinkäsittely
Other note
Parts
  • [Publication 1]: M.-K. Olkkonen, T. Laitinen, and P. Vainikainen, "Moisture Measurements of Bio-Material Web Using an RF Resonator Sensor," in Proc. of 9th International Conference on Electromagnetic Wave Interaction with Water and Moist Substances (ISEMA 2011), Kansas City, USA, May 31 - Jun. 3, 2011, pp. 1-7
  • [Publication 2]: M.-K. Olkkonen, V. Mikhnev, and E. Huuskonen, "RF Moisture Measurement of Concrete with a Resonator Sensor," in Proc. of 22nd International Crimean Conference Microwave and Telecommunication Technology (CriMiCo), Sevastopol, Ukraine, Sept. 10-14, 2012, pp. 853-854
  • [Publication 3]: M.-K. Olkkonen, V. Mikhnev, and E. Huuskonen-Snicker, "Complex Permittivity of Concrete in the Frequency Range 0.8 to 12 GHz," in Proc. of 7th European Conference on Antennas and Propagation (EuCAP), Gothenburg, Sweden, Apr. 8-12, 2013, pp. 3319-3321
  • [Publication 4]: V. Mikhnev, M.-K. Olkkonen, and E. Huuskonen, "Subsurface Target Identification Using Phase Profiling of Impulse GPR Data," in Proc. of 1th International Conference on Ground Penetrating Radar (GPR), Shanghai, China, Jun. 4-8, 2012, pp. 376-380.
    DOI: 10.1109/ICGPR.2012.6254894 View at publisher
  • [Publication 5]: E. Huuskonen-Snicker, V. Mikhnev, and M.-K. Olkkonen, "Discrimination of Buried Objects in Impulse GPR Using Phase Retrieval Technique," IEEE Transactions on Geoscience and Remote Sensing, vol. 53, no. 2, pp. 1001-1007, Feb. 2015.
    DOI: 10.1109/TGRS.2014.2331427 View at publisher
  • [Publication 6]: M.-K. Olkkonen, P. Eskelinen, E. Huuskonen-Snicker, T. Pellinen, and P. Olmos Martinez, "A New Microwave Asphalt Radar," in Proc. of IEEE Radar Conference (RADAR2014), Lille, France, Oct. 13-17, 2014, 5 pp.
    DOI: 10.1109/RADAR.2014.7060386 View at publisher
  • [Publication 7]: M.-K. Olkkonen, P. Eskelinen, E. Huuskonen-Snicker, T. Pellinen, and P. Olmos Martinez, "An Evaluation of the Permittivity of Two Different Rock Types Using Microwave Resonator and Waveguide Cutoff Principles," Frequenz, vol. 69 no. 1-2, pp. 75-82, Dec. 2014.
  • [Publication 8]: M.-K. Olkkonen, "Ku Band Ground Penetrating Radar for Asphalt Layer Measurement," IET Radar, Sonar & Navigation, vol. 10, no. 1, pp. 76-81.
    DOI: 10.1049/iet-rsn.2015.0133 View at publisher
Citation